Sliding Drawer Lock/Stopper

We recently purchased an IKEA SMÅSTAD storage bench, but the spot where we wanted it had a slant to the floor and the interior box on wheels kept rolling open. I designed this simple model so that I could mount the bar on top of the storage bench and slide on the locking piece from the side. The dovetail design only allows the locking piece to be removed by sliding it to the side, which works perfect for my purpose. It could also be used on doors or cabinets if there is a flat surface on top for it to stick to. If printed using the included profile, the stopper/lock measures just under 71 cm wide and just over 74 cm long, uses under 70g of filament and prints in about an hour and a half on my P1P. Just use a command strip or double sided tape on the smaller side of the bar. The locking piece will slide on/off from either side. I'd recommend putting the two pieces together and using the assembled unit to help align the placement of the adhesive.