Slicer Discord
Slightly Modified Light Switch Cover – Modelo 3D imprimible de Thingiverse Thingiverse

Slightly Modified Light Switch Cover

por msadler2
22 Descargas
20 Likes
0 Makes
Ver Modelo
I have my alarm clock plugged into the socket which is controlled by that annoying switch by the door. Someone is constantly touching that switch, and causing me to have to reset my ancient alarm clock. I am too stupid to move it.

In my kitchen, there are two switches on opposite sides of the room that operate the lights. One of them has a dimmer. Imagine the frustration when a randomized combination of switching and dimming causes me to waste half the morning replacing bulbs that don't work when in fact, they do.

So. I loved dfrechette's design so much, I stole it.

My light switch screws are countersunk. which meant that when I over tightened the screws, and I always over tighten the screws, I end up cracking the plastic.

I countersunk the holes.
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección