MakerWorld
Electronics
Go to Model
Slim Blink Mini Case
25
Downloads
14
Likes
16
Makes
This is a replacement case for the Blink Mini camera. I needed a smaller case for the camera and something to use as a starting point for mounting options. Sadly this is still too large to fit inside of my P1S, however many of you are more clever than i am. I dont think you can make a slimmer or smaller case, as the PCB is about 2mm smaller than the case. Super easy to print, ~20 min, and fits exactly. You will need to remove the camera from the stock housing first. There are 4 clips in the center of each side of the stock case that need to be released and the entire thing will slide apart. This case also provides the IR sensor room to show through so the camera still works in low light enviroments.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
