Slim Frog Case A and B with inserts

I remixed this from :
https://www.thingiverse.com/thing:4094861 and https://www.thingiverse.com/thing:4727941

The included enclosures are remixed from:
https://www.thingiverse.com/thing:4640334.

The closures were modified slightly (as they bumped the seam on this box and I found a few weak points when mounting. I also extended the 'hook' end so that it locks more securely. All the hinges and clasps use m3x20 screws, with the exception of the 'hinge' pin in the middle of the closure. I used a piece of scrap filament for this.

I used the bit holder version of the box for the base for the tri-hinge version, so it has a flatter bottom internally, while the top is concaved somewhat. I have included the bit holder that I used to fill the small bit holder version, as well as the full bit holder case. I had a lot of fitment issues with his bit holder, and as it has a lid I did not need a pressure fit for my bits. The bit holder insert is about .1 to .2 mm too large for the opening