Thingiverse
Slim Minimal Glock Mount
von StacksOnSusiesQ
7
Downloads
20
Likes
0
Makes
Designed for the Airsoft Glock 17 gen 4 model, it snuggly holds the trigger guard at a 30-degree angle. It should hold any version of the Glock pistol given the trigger guard is 15 mm across. It can be mounted with or without a standard magazine.
There are two versions. The 25mm version has a shallower bed where the bottom of the trigger guard rests. I have not tested this version out. The model in the picture is the 30mm version. I noticed there is a small gap that allows it to pivot (noticeable if magainze is heavy), the 25mm version is supposed to correct this. Note: the shallower bed (25mm) may not provide as much grip and worsen pivoting. Print at own risk.
20%infil 4 walls
support yes
There are two versions. The 25mm version has a shallower bed where the bottom of the trigger guard rests. I have not tested this version out. The model in the picture is the 30mm version. I noticed there is a small gap that allows it to pivot (noticeable if magainze is heavy), the 25mm version is supposed to correct this. Note: the shallower bed (25mm) may not provide as much grip and worsen pivoting. Print at own risk.
20%infil 4 walls
support yes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
