Slim Wallet

This is my take on the slim wallet. No glue or other hardware require to assemble the wallet. There are 3 different versions of the wallet, all of them use the same bottom and top covers. The 2 wallets from the pictures were printed on PLA and PTEG. The multicolor wallet was printed on PLA using the MMU2S at .2mm layer height, 15% gyroid infill and 3 perimeters using a .4 nozzle. The white one was printed on PTEG using the same settings as the PLA one. For the wallet that hold 4 cards use the files that stat with 4 mm, for the one for 5 cards use the files that start with 5 mm and the one for 6 cards use the files that start with 6 mm. The wallet consists of 8 parts and 5 pieces of filament (1.75mm): Top Cover Bottom Cover Middle Middle (X) Lever Clips (You will need 3) 5 pieces of filament cut to length according to the wallet size. To assemble the wallet start with the bottom cover, middle and the pieces of filament. You will need to clean the holes from the middle section a bit in o