Slime VR Tracker case YDNC

This is my own take at a case for Diy SlimeVR Full body trackers.
It is designed to use a 18650 Cell, a Weemos D1 mini, a MicroUSB Lithium battery charging board with Charge control and discharge protection and a MPU-6050 Module.

WARNING: To use this case you need a 12mm long microUSB cable like this:https://www.amazon.de/-/en/Connector-Blackview-BV6000S-Oukitel-Ulefone/dp/B07YS3Y1JR/ref=sr_1_3?crid=86FUBAOKD2QD&keywords=12+mm+micro+usb+kabel&qid=1657025708&sprefix=12mm+microusb+cabl%2Caps%2C122&sr=8-3

Or you need to make the wall with the holes slimmer, as it's 3mm thick at the moment.

The lid just holds onto the case by friction.

There is also a file for an MPU-6050 AUX tracker.

I named this case YDNC, because it equates to
"You Dont Need Circulation"
As the case has some sharp edges.


The cable going into the AUX tracker case has a diameter of 6mm and uses a zip tie as a pull-reinforcement