Thingiverse
slingfire nerf clutch-lock
von Amztel3d
16
Downloads
10
Likes
0
Makes
Hi all,
this is a piece that helps your prevent the clutch-lock slipping after upgrading to a stronger spring.
Just print 2 pieces removes the old(including the litte springs) and just push them into place, if its not working you can sand of a little bit.
I had no problem pushing it in with a flat screwdriver.
*upgraded with a 5KG spring and put a 3d printed washer 1cm in it.
Dont know for sure but think it will do even better with PLA+
Enjoy
this is a piece that helps your prevent the clutch-lock slipping after upgrading to a stronger spring.
Just print 2 pieces removes the old(including the litte springs) and just push them into place, if its not working you can sand of a little bit.
I had no problem pushing it in with a flat screwdriver.
*upgraded with a 5KG spring and put a 3d printed washer 1cm in it.
Dont know for sure but think it will do even better with PLA+
Enjoy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
