SlingKontrol v1.1

Sling Kontrol V1.1 "by" Qwerm A shameless ripoff of Subrev's Sling Control, a picatinny accessory that helps store your sling when not using your rifle. Changelog:-v1.1 Added looser fitting versions of the snap on version in order to make it easier to attach. I suggest SlingKontrol-Part1-Snap-Loose for a good balance between ease of installation and proper fit. Print orientation: Print everything on it's side. Settings used:Material: PLA+Extruder Temp: 210cBed Temp: 60cLayer Height: 0.2mmWall Line Count: 4Infill Percentage: 100%Support: NoneFuzzy Skin: OnFuzzy Skin Outside Only: OnFuzzy Skin Thickness: 0.1mmFuzzy Skin Density: 10.0/mm Materials Needed (Dont ask me why I mix metric and imperial parts):1/8 Inch Shock Cord2x M3x8 Screws1x 3/16 Dia. 1/4" Long Set Screw Directions:- Cut a length of shock cord and feed it through the larger part.- Insert both ends into the smaller part- Screw in both M3 screws until snug enough to keep the ends of the shock cord from pulling out but not enou