Thingiverse
Sloped Top Electronics Box
di Crayok
70
Download
41
Likes
0
Makes
Angled Top Electronics Box 1.4 April 2017
I needed an equipment box that would work as a hand holdable device, after looking through many designs here on Thingiverse I found some that came close but not fully.
The original intent was for a Wireless Launch System LCO controller case design for PIC microcontroller & Board, keypad, 4x20 display, li-ion charge circuit, 4 18650 li-ion battery pack and a 900Mhz modem.
Project Pics here:
https://www.flickr.com/photos/crayok/albums/72157604233331535
There are only three items printed, Base box that will hold the controller, modem and batteries with the top lid lower section housing the keypad that mounts from the bottom side (keypad flange inside box) There are two hole in this lid that are used to link the lid to the LCD display and angle section. The angle
section is variable in angle and length to accommodate the required display and function stuff.
Adding the extra detail for the inside components gives and idea how th
I needed an equipment box that would work as a hand holdable device, after looking through many designs here on Thingiverse I found some that came close but not fully.
The original intent was for a Wireless Launch System LCO controller case design for PIC microcontroller & Board, keypad, 4x20 display, li-ion charge circuit, 4 18650 li-ion battery pack and a 900Mhz modem.
Project Pics here:
https://www.flickr.com/photos/crayok/albums/72157604233331535
There are only three items printed, Base box that will hold the controller, modem and batteries with the top lid lower section housing the keypad that mounts from the bottom side (keypad flange inside box) There are two hole in this lid that are used to link the lid to the LCD display and angle section. The angle
section is variable in angle and length to accommodate the required display and function stuff.
Adding the extra detail for the inside components gives and idea how th
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
