Thingiverse
SM Pitot for Ardupilot
von Marco67
47
Downloads
46
Likes
1
Makes
This pitot was tested in flight with Ardupilot:Plane V3.9.8 (Pixhawk) on an ASW28 glider with a 4 meter wingspan, and did not give any problems.
It is imperative to print it correctly, the internal channels must be free from any obstacle, any filament residues may compromise its proper functioning.
I've designed three versions, use what seems most useful to your needs.
Follow the Ardupilot guide for calibrating an airspeed sensor during flight:
http://ardupilot.org/plane/docs/calibrating-an-airspeed-sensor.html
On my ASW28 the ARSP_RATIO goes to 1.4 after the in flight calibration.
Try it and leave me your feedback, thanks!
Good luck!
Simone Bonifazi and Marco Robustini
It is imperative to print it correctly, the internal channels must be free from any obstacle, any filament residues may compromise its proper functioning.
I've designed three versions, use what seems most useful to your needs.
Follow the Ardupilot guide for calibrating an airspeed sensor during flight:
http://ardupilot.org/plane/docs/calibrating-an-airspeed-sensor.html
On my ASW28 the ARSP_RATIO goes to 1.4 after the in flight calibration.
Try it and leave me your feedback, thanks!
Good luck!
Simone Bonifazi and Marco Robustini
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
