Thingiverse
Small Clamp
por ep1cman
8
Descargas
3
Likes
0
Makes
This is a small 3D printable clamp that uses a rubber band to provide clamping force.
**Assembly**
Once you have printed all three parts you will need to slide the sliding jaw of the clamp onto the shaft. After this you will need to glue the fixed jaw to the end of the clamp. Be careful to not get any glue onto the sliding part of the camp.
**Assembly**
Once you have printed all three parts you will need to slide the sliding jaw of the clamp onto the shaft. After this you will need to glue the fixed jaw to the end of the clamp. Be careful to not get any glue onto the sliding part of the camp.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
