MakerWorld
Office
Go to Model
Small Expo Holder
28
Downloads
3
Likes
8
Makes
Magnetic Small expo marker holder. I went a slightly different direction than some of the others on the market and tried to keep it simple by creating a tight enough seal on the markers so no cap is necessary and the markers should still seal around the edge. Made for a few friends in my community.Uses 30x10x3mm magnets inlaid for strong adhesion. Depending on model you may need to print .2mm for fine details.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
