Thingiverse
Small Fillament Spool
von Buellman75
5
Downloads
0
Likes
0
Makes
I made this up after I received a 10m length of ninjaflex off ebay which wasn't on a spool.
This doesnt need any supports, 10% infill printed in pla.
It has a couple of holes in the side to stop the fillament unravelling from the spool when not in use.
This doesnt need any supports, 10% infill printed in pla.
It has a couple of holes in the side to stop the fillament unravelling from the spool when not in use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
