Thingiverse
Small Oldham Coupler for Tevo Tarantula
door Gunnar333
129
Downloads
71
Likes
1
Makes
Hi,
this is my version of the oldham coupler for my Tevo Tarantula with two z-axis.
I made this version because I don't have enough room on my setup for other couplers.
I printed the middle part with support.
Top and bottom parts can be printed without support.
3mm screws are screwed directly in the part. No nuts. I used a screw tap for that.
this is my version of the oldham coupler for my Tevo Tarantula with two z-axis.
I made this version because I don't have enough room on my setup for other couplers.
I printed the middle part with support.
Top and bottom parts can be printed without support.
3mm screws are screwed directly in the part. No nuts. I used a screw tap for that.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
