Small Phone/Tablet stand with adjustable angle.

Compact phone and/or tablet stand which you can adjust the angle on (15, 25, 35, 50 degrees approx).

Needs 4 M3x10. I Printed with 4 walls/perimeter for added strength and at .32 layer height, but for a cleaner and stronger print go for a lower layer height. No supports, brims or rafts needed

I left my original design in the zip file as well in case you wanted a thicker stand.

The gap which the phone slots in is 11mm so if you have a phone/tablet thicker than 11mm, scale up all the pieces of the print cura.

I've only tested this on an iPhone and iPad but i don't see any reason why it won't work for anything else.

Edit: Oldcrow66 whos posted a pic of his make used M3x8 bolts and said they work fine.