Thingiverse
Small print in place hinge
von thinngimaker
15
Downloads
10
Likes
0
Makes
Print in place hinge for you to use in your projects. It can support at least 200g of weight.
Should be printed vertically, like in the picture.
The hinge can be mounted onto something using four M3 srews. I use threaded inserts to hold the screws, but that is optional. You can also use M3 nuts. The washers like in the picture are also optional, but recommended if you have some for more even weight distribution.
Print time is only about 20 minutes, so if your horizontal expansion value is off it won't be a big deal.
The distance between each of the two screw holes is 12mm.
Should be printed vertically, like in the picture.
The hinge can be mounted onto something using four M3 srews. I use threaded inserts to hold the screws, but that is optional. You can also use M3 nuts. The washers like in the picture are also optional, but recommended if you have some for more even weight distribution.
Print time is only about 20 minutes, so if your horizontal expansion value is off it won't be a big deal.
The distance between each of the two screw holes is 12mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
