Small Remote Control Stand - Updated 12-Jul

Designed this to hold those stupid little remotes that tend to come with stereo equipment, RGB lights and other Chinese products.

Holds remotes up to 40mm wide and 6mm thick - Or bigger if you increase the scale to suit.

Due to the nature of the cutout text design it may be best to print with supports enabled laying flat on it's front or back.

Edit: Printing from base to top works fine as long as the print speed is kept low enough to bridge the letters. Have printed the model tonight and will upload a photo when it's fully printed.

Edit: Increased Tolerance by 2mm all sides, was a very snug fit on the remote that it was pressing buttons.