Thingiverse
Small Scale Hydraulic Press
von Bazooka800
147
Downloads
127
Likes
0
Makes
1/24 Scale Hydraulic Press
I created this for a diorama, it is roughly 1/24 scale. I printed this in resin, but you could try to do it with filament. I would print it at least at [.16], the smaller the better to pick up the finer details.
After paint and decal, I drilled a small hole on the piston and control panel and ran a small hose between the two.
I created this for a diorama, it is roughly 1/24 scale. I printed this in resin, but you could try to do it with filament. I would print it at least at [.16], the smaller the better to pick up the finer details.
After paint and decal, I drilled a small hole on the piston and control panel and ran a small hose between the two.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
