Small Screwdriver Bit Organizer

#Small Screwdriver Bit Organizer

An organizer for small precision screwdriver bits (e.g. iFixit). I designed it to fit to my Proxxon/Dremel Bit Organizer.

##Model Details

* The organizer can fit 66 tool bits
* Dimensions (length x width x height): 101mm x 107mm x 72mm (3.98in x 4.21in x 2.83in)
* The holes are 5mm (0.19in) in diameter. Normally 4.5mm are enough, but I added some margin, to avoid any requirement of postprocessing the holes.
* The holes are 16mm (0.63in) deep
* the holes are shifted between the individual layers to make access easier.
* The lower tray is 25mm (0.98in) deep.

## Tips for printing

I originally had the lower half of the model hollow, but changed it after I sliced it and didn't found much improvement in print time compared to a version with low infill. As this model doesn't have high structural requirements, I made some changes to my default print profile.

* Reduce to 3 bottom layers (It is only a flat surface)
* Reduce to 5 Top layers