Thingiverse
Small sliding bolt
por Sagittario
237
Descargas
208
Likes
1
Makes
This is a small sliding cupboard/door bolt.
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run backwards. (be careful doing this,
The sliding bar is deliberately flat on one side so it can be printed horizontally.
I have added slots in the main body to allow the bolt to be locked into the opened and closed positions.
Assembly should be simple. just a little but not too much superglue on the pin when assembling the main body.
If the small pin is not printing properly, try laying it flat or maybe on a raft.
As for print settings, 50-80% infill at least 2 shells (perimeters)
If the body or receiver is too tight, try cleaning up with an 8mm drill run backwards. (be careful doing this,
The sliding bar is deliberately flat on one side so it can be printed horizontally.
Sagittario también publica en
76 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
