Thingiverse
Small Spoolholder refined
von drueben
5
Downloads
9
Likes
0
Makes
This is my version of the legendary Small Spoolholder.
1) The width is now perfectly optimized for 608 bearings
2) Implemented washer and spool guidance in the wall
3) Increased length for better stability
4) Cutout in the inner walls for extra full spools
(Those small diameter spools were always too full and the filament was touching the walls)
1) The width is now perfectly optimized for 608 bearings
2) Implemented washer and spool guidance in the wall
3) Increased length for better stability
4) Cutout in the inner walls for extra full spools
(Those small diameter spools were always too full and the filament was touching the walls)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
