Small World Insert with Some Expansions

I remixed a model I found on Thingiverse. The original model had manifold issues that I fixed in the slicer. I also added the race names to the lids to make it easier to remember where things go. There are 4 plates with lids:Original Lids (No Names) - I found these to be too tight. I had to pry it off with a screw driver.Loose Lids - These easily came off and looked a little big on the race trays when taken out of the game box.Snug Lids - These are tight enough that you can pick up the box by the lid. It took a few times of taking them off and on to get it to not be a little too hard.Good Lids - These were my preference as they were loose enough to come right off, but didn't look oversized when removed. I will note that this is probably due to the shrinkage of the PLA, so you might want to print a single lid and try it before printing the set. I set this up with 5% infill which seems to be sufficient to hold it together. I don't have all the expansions this can hold, but it wor