SMARS Robot L298N Mount

This is a replacement for the "holding board" part on the SMARS robot to hold an L298N motor controller. You'll need to print two of these. The holes are 3mm, and should work both with M3 screws as well as the #6-32 UNC screws used to secure CD-ROM drives in computers (I have a lot of these). I did not relieve the inside of the posts to allow for solder bumps on the bottom of the board; just don't tighten it too much (which honestly is good advice anyway).

This is a remix of a part from the SMARS Modular Robot. The remix search tool doesn't seem to be working right now, so here's the URL: https://www.thingiverse.com/thing:2662828