Thingiverse
smart filament sensor coupler
von YayBacon
3
Downloads
3
Likes
0
Makes
bigtreetech smart filament sensor to direct drive extruder coupler
easy to remove while filament is still loaded, for clearing jams in the extruder below
fits extruders with the plastic "push fit collars" that normally would hold a 4mm bowden tube...you can easily remove and insert the printed coupler
sensor should be relatively stable, but maybe adjust the horizontal expansion in your slicer if needed
easy to remove while filament is still loaded, for clearing jams in the extruder below
fits extruders with the plastic "push fit collars" that normally would hold a 4mm bowden tube...you can easily remove and insert the printed coupler
sensor should be relatively stable, but maybe adjust the horizontal expansion in your slicer if needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
