Smart Orbiter 3 (REVO) Hypercube Evolution Adapter

This is the adapter I designed to attach the Smart Orbiter 3 (Revo Edition) to my Hypercube Evolution.It should fit the standard Hypercube Evolution carriage with 3mm dowel pins.It should work as well for the original Smart Orbiter 3 since it's only 1mm shorter.Required hardware:1x M3 nut4x 3mm x 12mm dowel pins4x M3 screws 8mm long (in case you want to try to use a different screw length, the adapter is 5mm thick);1x M3 screw (this should be at least 6mm long to reach the nut into the adapter. You need to add the thickness of your carriage) Recommended Print Instruction:Use 0.2mm or 0.3mm layers, 5 perimeters, 4 top/bottom layers.I recommend to lay it flat on the side with the nut hole (I ensure you that you don't want to remove supports from the screw/pin holes). Assembly instruction:insert the dowel pin (a little hammering may be required);put the nut inside the adapter;attach the Smart Orbiter 3 to the adapter (pay attention to the fan cable! Depending on your needs you may