Thingiverse
SN04 Sensor Rear Bracket
von PaperMakeiT
9
Downloads
9
Likes
0
Makes
If you don't have much more room to place the SN04 sensor, than you can try this solution and install the sensor behind the X stock carriage.
There are two raws of holes: one for the stock head and the other for E3D V6 head.
The bracket includes the hexagonal fitting for 3mm nuts and bolts. For a better result warm up the nuts before applying them.
There are two raws of holes: one for the stock head and the other for E3D V6 head.
The bracket includes the hexagonal fitting for 3mm nuts and bolts. For a better result warm up the nuts before applying them.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
