Snackomat—An ESP32-Controlled Candy Dispenser

DescriptionThe Snackomat uses an ESP32-WROOM and a servo motor to automatically dispense candy. It is intended to be used with e.g. ESPHome and HomeAssistant to be triggered by the completion of tasks or certain events. There are two version of this print: One uses a transparent acrylic tube to see the left candy, the second version uses a printed tower for candy storage. Additional PartsESP32 WROOM (or ESP32 or Raspberry Pi Nano)Servo MotorGlueoptional: Transparent tube with 20mm inner & 21mm outer diameterChocolate Peanuts or Candy of your choiceAssemblySolder the Wires of the Servo to the ESP (See picture for reference)Glue the Servo into the Block (See picture for reference)For the ideal height of the Micro controller use a version with pins and clip the pins below the plastic. The casing is made to fit an ESP32 (WROOM). A Raspberry Pi nano is slightly slimmer. Fix the micro controller with glue if needed.The bottom part should fit rather tight without gluing.Use the small disc on