Thingiverse
Snake hounds
door Picklequest
101
Downloads
50
Likes
0
Makes
**Printing these were difficult. The best orientation I found was sideways and angled toward the head so the fangs did not require supports. See picture**
Printed on an Anycubic Photon S in:
Elegoo basic grey
.05mm resolution
9 sec. exposure time
8 bottom layers
60 sec. bottom layer exposure
1 sec. light-off delay
Printed on an Anycubic Photon S in:
Elegoo basic grey
.05mm resolution
9 sec. exposure time
8 bottom layers
60 sec. bottom layer exposure
1 sec. light-off delay
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
