MakerWorld
Organizers
Go to Model
Snap Cable Duct
7
Downloads
3
Likes
2
Makes
It's a cable duct. Nothing fancy.I needed one, I didn't want to buy it, so I printed it. It snaps open and closed just like the classic Legrand/Gewiss ones you find in any hardware store — press the lid down, pry it open with a flat screwdriver from the side.Specs:Body: 16 × 14 × 240 mmInner cavity: 12 × 12 mmSnap gap: 0.30 mmPrinted in PETG. I tried a few orientations and the only one that worked well for me was printing the body vertically — length on the Z axis. Horizontal kept warping on me at 240mm. Vertical: tiny footprint, no brim, no supports, came out perfect. That said, every printer is different — if you find a better way to orient it, drop a comment, I'm curious. It's just a cable duct. But it works.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
