Thingiverse
Snap case for PWM controller
von DrBlokmeister
48
Downloads
34
Likes
1
Makes
I needed a case for my [PWM controller](https://opencircuit.nl/Product/PWM-controller-6V-28V-3A) and was learning Fusion360 so I designed one.
I used [this youtube tutorial](https://www.youtube.com/watch?v=E0NVC8xhf3I) as a guide to make the case.
The case snaps together using two snap joints and is fixed by registration edges all around. The PCB is fixed in X and Y by four cylinders that fit in the PCB screw holes with 0.3 mm clearance and in Z by four cylinders that sit on top of the screw holes with 0.2 mm clearance.
I used [this youtube tutorial](https://www.youtube.com/watch?v=E0NVC8xhf3I) as a guide to make the case.
The case snaps together using two snap joints and is fixed by registration edges all around. The PCB is fixed in X and Y by four cylinders that fit in the PCB screw holes with 0.3 mm clearance and in Z by four cylinders that sit on top of the screw holes with 0.2 mm clearance.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
