Thingiverse
Snap Close Connector
by electrosync
6k
Downloads
4.4k
Likes
6
Makes
***If you get a 404 error when trying to download, go to Thing Files and download them individually***
**Model**
Snap close connector that's great for holding small items or fidgeting with. Two versions to chose from. Type 2 allows the connectors to connect to each other, but does require supports - take your pick.
**Build Video**
https://youtu.be/5h5bShThIvw
**Print Settings**
Nothing fancy here. Just regular 0.2 mm layer height and minimum 15% infill. Type 2 sides require supports.
**Hardware Required**
3 x M3 x 14 mm screws
3 x M3 washers
50 mm paperclip
Do not use one of these to hold any sort of load or in a situation that could injure you or someone else.
**More Electrosync**
[YouTube](http://youtube.com/user/electrosync)
[Instagram](https://www.instagram.com/electrosync)
[Website](https://electrosync.com.au/)
**Model**
Snap close connector that's great for holding small items or fidgeting with. Two versions to chose from. Type 2 allows the connectors to connect to each other, but does require supports - take your pick.
**Build Video**
https://youtu.be/5h5bShThIvw
**Print Settings**
Nothing fancy here. Just regular 0.2 mm layer height and minimum 15% infill. Type 2 sides require supports.
**Hardware Required**
3 x M3 x 14 mm screws
3 x M3 washers
50 mm paperclip
Do not use one of these to hold any sort of load or in a situation that could injure you or someone else.
**More Electrosync**
[YouTube](http://youtube.com/user/electrosync)
[Instagram](https://www.instagram.com/electrosync)
[Website](https://electrosync.com.au/)
electrosync also publishes on
12 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
