snap on camera arm extension

This is a remix of xTool D1 Camera clamp mount by Impulse819
I took the camera arm extension and added a cap that fits neatly over the support bracket. No need to screw or glue. Might need supports, I leave that up to you. This is large and will only fit diagonally on a built plate that is at least 330mmx330mm. This was designed in AnyCubic Next slicer (Orca based) using the built in model tools. In the attached picture I flipped the bracket 180 degrees to get my camera closer to the bed as it was a wide angle. The files attached have the support under the extension rather than above it and the CAD is flipped upside down to show the square hole.