Snap Rack Sliding Drawer and Top Panel

This model is for the drawer and top section of the Snap Rack. There are two print profiles. One is for a fully printed version because Snap Rack subscribes to the mantra of “everything printed when possible”. The second print profile is for use with M6 screws because they are easy and probably better if you plan to mount the Snap Rack in your off-road camper. If you already have a fully assembled Snap Rack, I recommend the M6 screw on approach, otherwise you have to disassemble your rack to install the full print version.The fully printed version uses printed locking knobs that screw in place. The head is designed to use the same hex driver that most M6 use. They do not need to be very tight to be effective. I have only used them finger tight. The holding part is the clip over ledge. The knobs just lock the plate. The drawer has a catch on the bottom to keep it from pulling all the way out and spilling your adapters on the floor and under the refrigerator. That is a new feature becaus