Snap-Together Universal Electrical Component Case

by Pizza Mama · Electronics

62 Downloads

8 Likes

24 Makes

This is a simple, snap-together enclosure for a 25mm x 50mm single-channel relay. There are slots on one side of the device to hold the relay in place by the circuit board. This can be used with any similar simple component with a 1.5mm PCB, just scale X and Y in Bambu Studio to fit your part! This can be printed with or without supports, but for best results, I suggest tree supports. Removal is easy with a pair of needle-nosed pliers. Boost MeConsider dropping a boost so I know what to make next!