Thingiverse
Snapmaker 2.0 Click Fix Toolhead
281
Download
114
Likes
0
Makes
This is a click fix system for the Snapmaker 2.0 Toolheads.
The fixtures require no mechanical parts and are fully printable.
The fixtures are made with small holes to allow for the insertion of 2mm neodymium magnets (Although this is not necessary). The fixtures do have very tight tolerances for obvious reasons.
I did not print the parts on the Snapmaker, only because I needed the parts to attach the tool heads first (Space behind the machine is limited.)
The "Clip Rev 2" was printed with 70% infill and the brackets were printed with 20. Supports were added with a 50-degree overhang angle and 20% density.
Please if there are questions or ideas to improve the design, let me know
The fixtures require no mechanical parts and are fully printable.
The fixtures are made with small holes to allow for the insertion of 2mm neodymium magnets (Although this is not necessary). The fixtures do have very tight tolerances for obvious reasons.
I did not print the parts on the Snapmaker, only because I needed the parts to attach the tool heads first (Space behind the machine is limited.)
The "Clip Rev 2" was printed with 70% infill and the brackets were printed with 20. Supports were added with a 50-degree overhang angle and 20% density.
Please if there are questions or ideas to improve the design, let me know
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
