MakerWorld
3D Printer Accessories
Go to Model
Snapmaker 2.0 Enclosure Display Cap
10
Downloads
3
Likes
3
Makes
A simple cap for the display hole in the Snapmaker 2.0 Enclosure. I've fixed my display in another location outside the enclosure (last picture) and this left a hole where it was by design which isn't best when using the laser head or printing ABS etc.. So this is a quick snap-on cap, the older version is a little harder to install while the newer one has some holes to allow the partial separation of the two long parts of the inserts from the main plane thus allowing them to flex.Tested on A250 and A150 enclosure, should work on A350 too to my knowledge.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
