Snapmaker 2 3DP Module Wire Entry Cover

Good day everyone!

This is in regards to a forum thread for Snapmaker 2 https://forum.snapmaker.com/t/3dp-part-cooling-fan-5015-replacement/10038/93

It's time to unveil my contribution to the blower mod upgrade!

Starting with Brent's printed mod, the blower itself, the diode, the double sided tape and the pack of connectors with wire leads, I completed the work as indicated above with success.

I have now taken this a little bit further.

In order to get the wires inside of the print head neatly, while also allowing room for the connector and excess wire, I have created a replacement side plate for the module.

Keep in mind, I have done very little modeling and was really struggling with using fusion360 (interface is very unintuitive and at some point they just stop letting you edit the shape without starting over) so the radius of the corners is not an exact match, but first lets take a look at the original vs my new one:

Seemingly quite similar, grill holes, screw h