Thingiverse
Snapmaker A350 Filament guide
di sdj544
82
Download
38
Likes
2
Makes
Filament guides for Snapmaker A350
UPDATE: After using for a while I now prefer the B version with the circular guide. The long skinny one was just too easy to bump into and snap off while doing other stuff.
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.
UPDATE: After using for a while I now prefer the B version with the circular guide. The long skinny one was just too easy to bump into and snap off while doing other stuff.
I was able to keep my filament roll inside the the enclosure by just lowering it a few screw holes.
The only problem I've found with this is that the filament will sometimes wrap around the z-tower (especially after going to home position) This keeps it from doing that.
I printed this in PETG but PLA should work just fine.
Not sure if it would work on an A250. Let me know if it does.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
