Thingiverse
Snapmaker CNC - Screw Mount
von bmxorcist
20
Downloads
4
Likes
0
Makes
Sick of slamming your head against those bulky Snapmaker clamps?
Ready to try something a little less intrusive?
Introducing.. the Snapmaker CNC - Screw Mount!
Just bolt these guys around the perimeter of your stock, screw into your stock through the sides, and you are ready and steady with a flush-mount system!
Tested with a A350 on (common measurement) 6" and 12" boards (both 1/2" and 1" thickness), available at your local hardware store.
Additional parts:
-M4 30mm screws, included with your snapmaker
-#4 1/2" wood screws, also available at your local hardware store.
WARNING:
Be wary of the screw within the stock! Do not attempt to mill through the screws, or you'll have a bad time! The 1/2" screw protrudes from the mounting block by ~10 mm, so Leave at least that distance of stock around the edges where your mounts will be.
Ready to try something a little less intrusive?
Introducing.. the Snapmaker CNC - Screw Mount!
Just bolt these guys around the perimeter of your stock, screw into your stock through the sides, and you are ready and steady with a flush-mount system!
Tested with a A350 on (common measurement) 6" and 12" boards (both 1/2" and 1" thickness), available at your local hardware store.
Additional parts:
-M4 30mm screws, included with your snapmaker
-#4 1/2" wood screws, also available at your local hardware store.
WARNING:
Be wary of the screw within the stock! Do not attempt to mill through the screws, or you'll have a bad time! The 1/2" screw protrudes from the mounting block by ~10 mm, so Leave at least that distance of stock around the edges where your mounts will be.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
