Thingiverse
Snapmaker cooling fan duct
von PrintShed
82
Downloads
48
Likes
0
Makes
This is my version of a cooling fan adaptor/duct for the standard Snapmaker cooling fan.
A few important points;
- The clearance for the print bed is close. I recommend that the clearance is tested by manually jogging the machine to the home position first.
- I recommend printing with the large fan opening down, with supports enabled. This gives a cleaner finish at the nozzle end.
- I have extensively tested the part with a nozzle temperature up to 210C, with no issues. I have not yet tested the part under higher nozzle temperatures.
A few important points;
- The clearance for the print bed is close. I recommend that the clearance is tested by manually jogging the machine to the home position first.
- I recommend printing with the large fan opening down, with supports enabled. This gives a cleaner finish at the nozzle end.
- I have extensively tested the part with a nozzle temperature up to 210C, with no issues. I have not yet tested the part under higher nozzle temperatures.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
