Snapmaker Dust Covers V2

This is a revision to my previous design. After long term use I worked in a few improvements. I tightened up the fit, adjusted a few travels and added stops for the X and Y axes. The stops are set at the height of the CNC platform in the Y direction to support materials that are longer than the work table. The X version is a little smaller to save uneccesary printing time and material.

I have also added two connector thicknesses, one for the print bed and one for the CNC bed. Use the CNC connectors for the X and Y axes and swap between the two when changing the print bed. You can use the CNC connector on the print bed but it leaves a small gap between the connector and the build plate. This could cause them to become disconnected if there is a jam.

I've also added a dedicated Rear Z slide to fit without trimming since it didn't always trim clean.

As before, I printed everything in PLA except for Slides 4 for the X and Y axes. Those need to be in ABS or similar material to with