MakerWorld
3D Printer Accessories
Go to Model
Snapmaker J1 Filament Rack & Guide
14
Downloads
4
Likes
2
Makes
Are you sick of having to give your J1 a reach around every time you want to change your filament? I was so I made these spool racks that use existing threaded frame holes. I used some spare PTFE tubing and ran it into the guide so the filament went straight off the spool into the tube then through the frames existing holes at the back of the print etc. Right and Left model included.Enjoy! : )
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
