Thingiverse
Snapmaker Pi Camera Mount & Holder
door kelvin8r
378
Downloads
163
Likes
4
Makes
This is an attachment for mounting a Raspberry Pi Camera to the Snapmaker if you're running OctoPrint.
The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
The Pi Camera case and bracket are remixed from this mount https://www.thingiverse.com/thing:2265949.
Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in **Print Settings** below.
The arm swings from the front to 90 degrees to the right side of the printer bed. There are notches in the base in 15 degree increments.
The Pi Camera case and bracket are remixed from this mount https://www.thingiverse.com/thing:2265949.
Everything is snap fit, except for mounting the base to the printer and mounting the arm to the base. Details in **Print Settings** below.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
