Thingiverse
Snapmaker U1 Bed Manual Level Tool
por Dimiko
7
Descargas
21
Likes
0
Makes
In certain cases, you may need to manually level the print bed of the Snapmaker U1.
Fortunately, this is done via the firmware on the display. You need to turn a knob at each of the four corners under the bed, following the instructions. If you have trouble with the size of these knobs, you can use one of my adjustment tools, which makes the whole process a bit easier!
The function is the same for all six knobs; the only difference is the grip. You can print whatever you like.
I printed it with PETG, but PLA should also work fine.
Fortunately, this is done via the firmware on the display. You need to turn a knob at each of the four corners under the bed, following the instructions. If you have trouble with the size of these knobs, you can use one of my adjustment tools, which makes the whole process a bit easier!
The function is the same for all six knobs; the only difference is the grip. You can print whatever you like.
I printed it with PETG, but PLA should also work fine.
Dimiko también publica en
28 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
