Snapmaker U1 Feeder Relocation – Rear Position

***UPDATE 10.04.2026I have replaced the profiles with ones containing four build plates. The following versions are included:V1.0 - classic version with feeder holders that fit snugly to the housing curves, PC4-M6V1.1 - classic version with feeder holders that fit snugly to the housing curves, PC4-M10V2.0 - version with flat contact surface and larger channels for extensions, PC4-M6V2.1 - version with lflat contact surface and larger channels for extensions, PC4-M10Since some users have reported that the filament cannot be fed all the way to the prefeeder and tends to jam when using PC4-M6 fittings, I recommend printing one of the PC4-M10 versions. With these connectors, the tubes can be guided through the fitting all the way to the prefeeder.Let me know if, against expectations, anything does not fit properly.Overall, I would really appreciate feedback on V2.1. And of course also on the other versions.Since there also seem to be differences in the prefeder mounting between the crowdfu