MakerWorld
3D Printer Parts
Model downloaden
Snapmaker U1 - Tapo Camera Mount
80
Downloads
22
Likes
30
Makes
Simple mount for Tapo C100 cameras for use with the Snapmaker U1, allows a different viewing angle when monitoring prints and a high frame rate. Remove the screw cover grommet on the corner you wish to install the camera and store in a safe location. Remove the screw and place through the hole in the mount. Screw the mount back into place where the grommet was, and snap the camera rod into the mount. Prints without supports.
Cryostatic publiceert ook op
19 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
