Thingiverse
Snapper7 4in1 frame replacement
door corristo25
23
Downloads
19
Likes
0
Makes
Hi
After few test of printed single mount it turned out that is not durable enough.
This is my new design for replacement of Snapper 7 alu mountings.
All in one construction, which is more rigid. Unfortunately it is heavier (~2g) than original alu mounting.
You will use the same screws which are used in Snapper. So no need for additional materials.
After few test of printed single mount it turned out that is not durable enough.
This is my new design for replacement of Snapper 7 alu mountings.
All in one construction, which is more rigid. Unfortunately it is heavier (~2g) than original alu mounting.
You will use the same screws which are used in Snapper. So no need for additional materials.
corristo25 publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
