Snapware 40 cup Dry Box

Want a dry-box that holds more than a single filament spool and isn't a huge box? Me too!

The main rod is designed so spool sits on the bearings for a smooth non jerky filament feed. The main rod has a separator guide in the middle to keep a single roll from rolling to the other side .

Some force, or sanding, may need to be applied to get the bearings on the pole. It should be a tight fit to keep the bearings from moving around. "Bearing Helper" file is to yelp you install bearings on the rod. place bearing on top of cone and tap rod through bearing into the helper. Just like hammering a nail. The bearing should be about a fingers width on the rod.

M3 screws will be needed to secure the bracket to the container walls. If worried about air leaks around the screws i recommend either O-rings, or a dab of E6000 glue in the hole when inserting the screw.

I recommend aligning the filament pass-through with the top or bottom of the filament roll. I placed mine in the middle and