Thingiverse
SneakerHead Aesthetic Emblem
von NathaOne777
0
Downloads
1
Likes
0
Makes
anti-warp settings:
- *Bed Temperature*: 50-60°C (for PLA)
- *First Layer Height*: 0.2mm
- *Brim Width*: 5-10mm
- *Fan Speed*: 0-20% (first few layers)
- *Adhesion*: Use glue or hairspray
These settings help minimize warping. Adjust based on your printer and material.
- *Bed Temperature*: 50-60°C (for PLA)
- *First Layer Height*: 0.2mm
- *Brim Width*: 5-10mm
- *Fan Speed*: 0-20% (first few layers)
- *Adhesion*: Use glue or hairspray
These settings help minimize warping. Adjust based on your printer and material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
